Skip to content

Settings

The Everything Presence Grid panel's Settings view is where you tune the device's behaviour after the basics are in place. Each section is covered on its own page:

  • Entities — enable or disable individual Home Assistant entities.
  • Detection ranges — how far each mmWave radar is allowed to see.
  • Sensor calibration — sensitivity and timing for the motion and static sensors, plus offsets for the environmental readings.
  • LED and relay — LED modes, colours, brightness; relay trigger mode and contact mode.
  • Logging — per-component firmware log levels.

Note

The panel automatically hides controls for hardware a model doesn't have. On an Everything Presence Lite you won't see the static sensor, motion, temperature/humidity, LED mode, or relay controls.